Transition fitting HD-PE/V2A with male thread
Transition fitting MUN V2A
- Water
- Working pressure: PFA (water) 16 bar
- Thread: DIN EN 10226-1,
- Wrench size: DIN 475-1
- Material: Stainless-steel 1.4305 (X8CrNiS18-9)
- Safety technology
Note:
Stainless Steel-nipple, non-detachable and twist-proof, over molded with HD-PE.
Safe absorption of torsional moments up to 30 Nm.
PE 100-RC SDR 11
Maximum permissible working pressure 16 bar (water)
| Reference | d | R | B | D | h | L | t | z | SW | Weight |
|---|---|---|---|---|---|---|---|---|---|---|
| 617189 | 40 | 1" | 67 | 51 | 23 | 104 | 45 | 59 | 46 | 0,300 |
| 617190 | 40 | 1 1/4" | 67 | 51 | 23 | 107 | 45 | 62 | 46 | 0,336 |
| 617191 | 50 | 1 1/2" | 78 | 64 | 28 | 116 | 52 | 64 | 50 | 0,412 |
| 617192 | 63 | 1 1/2" | 93 | 80 | 31 | 120 | 52,5 | 67,5 | 60 | 0,609 |
| 617193 | 63 | 2" | 93 | 80 | 31 | 124 | 52,5 | 71,5 | 60 | 0,632 |
Areas of Application
The FRIALEN transition pieces MUN 2VA are screw connections for transitioning from stainless steel to HD-PE. The FRIALEN coupler is integrated into the fitting.
Assembly Instructions
During assembly, the component may only be screwed into the metallic counterpart using a wrench attached to the factory-installed metallic hexagon.
The fusion of the HD-PE side takes place by FRIALEN-fusing – leakproof and longitudinally strong.
The installation of the stainless-steel side and the HD-PE side must be prepared according to the general installation instructions (see” Transition Pieces” in ” Assembly Instructions” for FRIALEN-Safety Fittings for sustainable
pipes for gas, water networks and industrial systems made of PE”).
Removing the oxide layer and cleaning.
Good reasons for using FRIALEN MUN V2A
- Compact design
- HD-PE saddles with Open Wire Technology for optimum heat transfer
- No holding clamps required
- Stainless-steel-nipple, non-detachable and twist-proof, over molded with HD-PE
- Safe absorption of torsional moments up to 30 Nm
- Additional barcode for tracing back the fitting (Traceability-Coding)
- Suitable for use in high humidity or industrial environments