Transition fitting HD-PE/brass with female thread
Transition fitting MUM
- Water
- Working pressure: PFA (water) 16 bar
- Thread: DIN EN 10226-1, Wrench size according to DIN 475-1
- Material: Lead-free brass CW724R
- Safety technology
Note:
Brass nipple, non-detachable and twist-proof, over molded with HD-PE.
Safe absorption of torsional moments up to 30 Nm.
PE 100-RC SDR 11
Maximum permissible working pressure 16 bar (water)
| Reference | d | Rp | B | D | h | L | t | z | SW | Weight |
Pallet quantity |
|---|---|---|---|---|---|---|---|---|---|---|---|
| 617158 | 32 | 1" | 60 | 42 | 21 | 100 | 44 | 78 | 41 | 0,223 | 1080 |
| 617159 | 40 | 1 1/4" | 67 | 51 | 23 | 103 | 45 | 79 | 50 | 0,372 | 800 |
| 617160 | 50 | 1 1/2" | 78 | 64 | 28 | 110 | 52 | 34 | 60 | 0,540 | 600 |
| 617161 | 63 | 1 1/2" | 93 | 80 | 31 | 114 | 52,2 | 37 | 60 | 0,647 | 300 |
| 617162 | 63 | 2" | 93 | 80 | 31 | 119 | 52,5 | 38 | 70 | 0,749 | 400 |
Areas of Application
The FRIALEN transition pieces MUM are screw connections for transitioning from brass to HD-PE. The FRIALEN coupler is integrated into the fitting
Assembly Instructions
During assembly, the component may only be screwed into the metallic counterpart using a wrench attached to the factory-installed metallic hexagon.
The fusion of the HD-PE side takes place by FRIALEN-fusing – leakproof and longitudinally strong.
The installation of the brass side and the HD-PE side must be prepared according
to the general installation instructions (see” Transition Pieces” in” Assembly Instructions for FRIALEN-Safety Fittings for sustainable pipes for gas, water networks and industrial systems made of PE”).
Removing the oxide layer and cleaning.
Good reasons for using FRIALEN MUM
- Compact design
- HD-PE saddles with Open Wire Technology for optimum heat transfer
- No holding clamps required
- Brass-nipple, non-detachable and twist-proof, over molded with HD-PE
- Safe absorption of torsional moments up to 30 Nm
- Additional barcode for tracing back the fitting (Traceability-Coding)